
© 1998–2003 Schneider Electric All Rights Reserved
Chapter 1—Overview VVDED397047USR6/03
Keypad Display 06/2003
12
Mounting
To mount the keypad display, first remove the protective cover. Insert
the keypad display into the SUB–D connector and turn the retaining
screw clockwise until finger-tight.
The keypad display can be mounted and removed while there is
power to the drive controller. If the keypad display is removed while
command of the drive controller from the keypad display is active, the
drive controller will trip on the serial link fault. See SLF in Table 27
beginning on page 103.
Remote Mounting
To remotely mount the keypad display, use the keypad display
remote mounting kit, part number VW3A58103. This kit has an IP65
rating. It contains a three meter (9.8 ft.) cable with connectors, parts
Figure 1: Removal of Protective Cover
Figure 2: Drive Controller with Keypad Display Mounted
E
S
C
E
N
T
R
U
N
F
W
D
R
E
V
STOP
R
E
S
E
T
FAULT
POWER
z
Retaining Screw
Kommentare zu diesen Handbüchern