
© 1998–2003 Schneider Electric All Rights Reserved
VVDED397047USR6/03 Chapter 1—Overview
06/2003 Keypad Display
11
Keypad Display
The keypad display allows:
• Display of the drive controller part number, electrical values,
parameters, and faults
• Adjustment and configuration of the drive controller
• Local command
• Storage of four controller configurations which can be read or
downloaded to multiple drive controllers of the same horsepower
and firmware revision
3Q 2002
V5.1 IE 32
V5.2 IE 09
[1]
V5.1 IE 19
V5.2 IE 27
[1]
Launched the ATV58 TRX series.
Extended the product range to include the 125–500 hp drive
controllers for variable torque applications.
Added an analog output to the product.
The following functions were added:
• Ability to run at the last speed on loss of follower, RLS.
• Increased adjustment range on two PI parameters, RPG and
RIG.
• Ability to assign a logic input to an external fault contact,
EDD.
• Ability to assign a logic output to drive temperature alarm
and select alarm point, tAd and dtd.
2Q 2003 V5.3 IE 43 V5.3 IE 32
The following functions were added:
• The ability to adjust the motor speed from the customer-
defined units display, LCU, while in local control mode, using
the keypad display’s up/down arrow keys.
• Enhanced auto restart functionality to allow setting the
number of restart attempts, nAr, and the time delay between
attempts, tAr.
• The ability to change output phase rotation (motor direction)
using parameter ACb.
[1]
V5.2 IE 09 is the 125–500 hp revision and can use keypad display firmware revision V5.1 or greater.
Table 2: Product Upgrade and Revision Level History (continued)
Date
Drive
Controller
Firmware
Revision
Associated
Keypad
Display
Firmware
Revision
Description of Major Function Upgrade
Kommentare zu diesen Handbüchern