Schneider Electric Xantrex XW Installationsanleitung PDF herunterladen (Seite 39)

Step 4: Wiring the Inverter

975-0239-01-01 2–9

This manual for use by qualified personnel only

Step 4: Wiring the Inverter

This section provides procedures for making AC and DC connections between

the Xantrex XW Inverter/Charger and the power distribution panel using the

cables that are pre-installed in the distribution panel. This section also assumes

that the Xantrex XW Conduit Box was installed in the previous section.

For diagrams and information about installing the inverter/charger without the

Xantrex XW Conduit Box and Xantrex XW Power Distribution Panel,

see Appendix C.

Installation Tip Before making the AC or DC cable connections, route the communications

cables through the raceway, but do not connect them to their components until

after all the inverter connections are made. Once the AC and DC connections are

made the run becomes difficult to access. Use different colors for the

communications cables (or cable tags) to help make them easier to identify.

Important: Communication and signal cables must be segregated from all DC

and AC wiring. Therefore, a small raceway has been included in the design of

both the Xantrex XW Power Distribution Panel and the Xantrex XW Conduit Box to

separate the communications cables from the power cables. This is a small

raceway run built into the bottom of both the Xantrex XW Power Distribution Panel

and the Xantrex XW Conduit Box and is held in place by a single screw at the top

of the raceway.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 165 166

Keine Kommentare

Schneider Electric Xantrex XW Installationsanleitung Seite 39