Schneider Electric Xantrex XW Installationsanleitung PDF herunterladen (Seite 42)

Installation

2–24 975-0540-01-01 Revision B

This guide is for use by qualified personnel only.

5. Configure PV input (PV In) and DC output or the battery bank (DC Conn). If

the system only has one battery bank, leave DC Conn at the default setting.

The PV In setting allows you to differentiate which array is going to which

charge controller. This setting is used for status reporting only, not for any

internal controls. Setting PV In to a non-default value is optional.

6. Press Exit until the Config menu is displayed.

7. Scroll to Charger Settings, and then press Enter.

The Chgr menu opens.

8. Set the battery type (Batt Type), battery capacity (Batt Capacity), and

any other charger settings required for your system. If you select Custom for

the battery type, you can further configure bulk, absorption, float, and other

settings for the charge cycle in the Custom Settings menu that appears.

9. While in the Chgr menu, make sure the nominal battery voltage

(Batt Voltage) is set correctly. The default value is 48 V. If your system is a

24 V battery system, then change it to 24 V.

10. Press Exit until the Select Device menu is displayed.

Copying Settings to Another Charge Controller

Settings that are copied from one charge controller to another are:

• Batt Type

• Batt Capacity

• Max Chg Rate

• Charge Cycle

• ReCharge Volts

• Absorb Time

• Default Batt Temp

• Batt Voltage

• DC Conn

• Custom battery settings (if Custom battery type selected) including Eqlz

Support, Eqlz Voltage, Bulk Voltage, Absorb Voltage, Float

Voltage, and BattTempComp.

WARNING

HAZARD OF FIRE AND EXPLOSION

• Do not copy settings from one charge controller to another unless the

battery banks are identical: same size, type, and so on.

• See the Xantrex XW MPPT 80 600 Solar Charge Controller Operation Guide

for additional configuration information and details including setting

descriptions and value ranges.

Failure to follow these instructions will result in death or serious injury.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 61 62

Keine Kommentare

Schneider Electric Xantrex XW Installationsanleitung Seite 42