Schneider Electric FX 3NET Wartungshandbuch PDF herunterladen (Seite 17)

Installation Instruction 66571764GB3 Fire Detection 17

Schneider Electric Pelco Finland Oy Kalkkipellontie 6, 02650 Espoo, Finland Telephone: +358 10 446 511 Fax: +358 10 446 5103 www.pelco.com/nordic

Document Number 66571764GB3 16 2012

OCA jumper settings

1. Check the following settings:

Set the right ID. The range is 1…4/FX and FXL panel. The

ID must be different for each IOC and OCA.

9. Control panel test run: Note differences with the FXS!

9.1 Mains connection

Note! The panel is in access level 2 when the cover is removed.

1. Switch the panel on by connecting the cable between

the transformer and the terminal 30VAC on the power

supply component board.

FXS: Connect power supply cables “P1” and “P2” to the

MC2 PI1 and PI2 terminals.

The backlight of the display flashes for about 20 s.

The display will show the text:

The text “Panel starting up” will disappear from the display

when all addresses are scanned for presence.

13:36 14.09.2007

Fire Panel

Activate menu by pressing wheel

Panel starting up

After approximately one minute from start the panel will

indicate a fault alarm due to the missing battery:

Note: FXS does not give any fault alarm, because there in

FXS is not built-in power supply and battery.

Buzzer beeps continuously.

FAULT-led blinks.

LCD display shows:

FAULT 1/1

PS battery fault

Panel starting up

2. Press the “BUZZER SILENCE”- button.

The audible signal is silenced.

The “FAULT”- led becomes fixed.

The LCD remains the same.

The panel will also indicate a fault alarm for missing.

configuration data if the panel is not configured.

This fault alarm can be reset and will not appear again.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 57 58

Keine Kommentare

Schneider Electric FX 3NET Wartungshandbuch Seite 17