Schneider Electric Mupgrade Utility Installationsanleitung PDF herunterladen (Seite 29)

Introduction and Installation

1–18 975-0720-01-01

This manual is for use by qualified personnel only

Charge

Use this feature to enable or disable charging on all applicable devices.

Clear All Faults/Warnings

To clear all system faults and warnings, click Clear All Faults/Warnings.

Enable Broadcasts

Use Enable Broadcasts to re-enable Xanbus network messages. See Chapter 5,

“Upgrading Firmware”.

Exit

To quit Conext Configuration Tool, click Exit.

Configure Menu Features

Connection Names

If you have a Conext System Control Panel (SCP) on your Xanbus network, you

can easily change the system connection names by using Connection Names.

Note: This feature is only available if an SCP is installed on your Xanbus network.

To set the connection names:

1. In the Configure menu, click Connection Names.

2. Click the tab for the type of association you wish to set (Grids, AC Loads,

Generators, Batteries, or Solar Arrays).

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 129 130

Keine Kommentare

Schneider Electric Mupgrade Utility Installationsanleitung Seite 29