Schneider Electric Modbus Plus Network Bridge Multiplexer none Bedienungsanleitung PDF herunterladen (Seite 11)

Chapter 3 Connecting to a Controller

Configuring TCP/IP communications l 45

Ÿ You must install the TCP/IP Configuration Extension into your

controllers to set TCP/IP addresses for their communication cards.

v For more information, see “TCP/IP extension” on page80.

Ø To select and configure TCP/IP communications:

1. From the ProWORXNxT Title Screen or from the Offline Network

Editor, on the Controller menu, click Communications Setup.

2. From the Interface list on the left of the Communications Setup dialog

box, select TCP/IP.

3. In Timeout, enter a type that specifies the length of time the PC will

wait for successful communication with a controller before displaying

an error message. Default is 2 seconds.

4. Click OK.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Keine Kommentare

Schneider Electric Modbus Plus Network Bridge Multiplexer none Bedienungsanleitung Seite 11