Schneider Electric PowerLogic PM5300 Series Betriebsanweisung PDF herunterladen (Seite 18)

PowerLogic™ PM5300 series user guide Chapter 3—Hardware Reference

Meter mounting

This section describes how to mount the meter.

Mounting the PM5300

The meter is designed to be mounted inside a 1/4-DIN panel cutout.

1. Inspect the gasket (installed around the perimeter of the front display) and make sure

it is secured properly and not damaged.

2. Insert the meter through the mounting hole.

3. Line up the tabs of the retainer clips with the slots on either side of the meter. While

holding the retainers at a slight angle, push the retainers in and forward to position

them in place. In situations where the spacing between meters is tight, use a flat-head

screwdriver with a long, narrow shaft to help secure the clips.

90.00°

96.00mm

96.00

78.5 mm

12.8 mm

107.4

90.6

72.00 mm

92.0

+0.8

0.0

92.0

+0.8

0.0

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 119 120

Keine Kommentare

Schneider Electric PowerLogic PM5300 Series Betriebsanweisung Seite 18