Wiser
TM
Thermostat Remote Temperature Sensor S1B35793
Instruction Bulletin Rev. 01, 08/2011
Electrical equipment should be installed, operated, serviced, and maintained only by
qualified personnel. No responsibility is assumed by Schneider Electric for any
consequences arising out of the use of this material.
Wiser™
and Schneider Electric™
are trademarks or registered trademarks of
Schneider Electric. Other trademarks used herein are the property of their respective
owners.
Schneider Electric USA, Inc.
8001 Knightdale Blvd
Knightdale, NC 27545 USA
1-888-778-2733
www.schneider-electric.us
© 2011 Schneider Electric All Rights Reserved2-EN
ENGLISH
5. Open the remote temperature sensor cover. Connect the data wires of the
shielded cable to the wires on the temperature sensor using the supplied
wire splices. Wrap the shield around the jacket of the cable and tape it.
6. At the thermostat, make the connections to the Green and Black
terminals under the section marked “Remote Temp Sensor” on the right
terminal strip. Note that the shield and one of the wires from the remote
temperature sensor are tied together and must be connected to the
Black terminal. See the figure below.
Configuration Reconnect the thermostat to the base and configure the remote temperature
sensor according to the application.
Use the thermostat’s temperature sensor installation settings (see the Installer’s
Guide supplied with your thermostat) to configure the internal temperature
sensor and the optional remote temperature sensor. If any temperature sensors
are set as the same type (for example indoor or outdoor), the thermostat will
display the average temperature reading of the sensors.
Internal Sensor: This enables or disables the onboard temperature
sensor for indoor use only. The default setting is enabled.
Remote Sensor 1: This enables the remote temperature sensor for
indoor or outdoor use. The indoor and outdoor temperatures are
averaged among all sensors of the same type. The default setting is
disabled.
Operation Check that the indoor temperature is displayed on the thermostat’s
Temperature screen. If the remote temperature sensor is configured as
outdoor, check that the outdoor temperature is displayed in the thermostat’s
Message Bar.
If the thermostat does not display a temperature, contact the Schneider Electric
Customer Care Center. Call toll free 1-888-778-2733.
UP
Thermostat
Temp. Sensor
Shield
Shield
Red
Green
Black
Remote
Temp
Sensor
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern