Schneider Electric EER57200 Bedienerhandbuch PDF herunterladen

™

Instruction Bulletin

S1B35793

Rev. 01, 08/2011

Replaces S1B35793, 07/2011

Wiser™ Thermostat Remote Temperature Sensor

Model EER57200

Retain for future use.

ENGLISH

Description The EER57200 is a surface mount temperature sensor for use with Wiser

Programmable Communicating Thermostats, models EER56000 and

EER56100. The sensor can be:

• Connected to a Wiser thermostat to monitor the temperature of a remote

location

• Combined with an onboard temperature sensor to average the

temperature of two locations

• Used to monitor the outdoor temperature

The remote temperature sensor is required for Wiser thermostats used in dual

fuel heat pump installations.

Safety Precautions This section contains important safety precautions that must be followed before

attempting to install, maintain, or troubleshoot electrical equipment. Carefully

read and follow the safety precautions below.

Installation 1. Install the thermostat base and connect it to the HVAC equipment.

Consult the HVAC manufacturer’s instructions and the thermostat

Installer’s Guide.

2. Connect the thermostat to the base and confirm that the thermostat

operates correctly.

3. Disconnect the thermostat from the base.

4. Run a twisted pair, shielded cable from the remote thermostat to the

mounting location of the temperature sensor. Follow these guidelines or

product performance may be degraded:

— Wire runs must not exceed 250 feet.

— For distances up to 100 feet, typical twisted pair, PVC-insulated

shielded cable must be used.

— For distances from 100–150 feet, twisted pair shielded cable with

polypropylene insulated conductors must be used.

— For distances from 150–250 feet, twisted pair shielded cable with

foam-polyethylene insulated conductors must be used.

DANGER

HAZARD OF ELECTRIC SHOCK

• Apply appropriate personal protective equipment (PPE) and follow safe

electrical work practices. See NFPA 70E.

• This equipment must be installed and serviced by qualified electrical

personnel.

• Turn off all electrical power supplying this equipment before working on

or inside the equipment.

• Always use a properly rated voltage sensing device to confirm that

power is off.

• Replace all devices, doors, and covers before turning on power to this

equipment.

Failure to follow these instructions will result in death or serious

injury.

1 2 3 4 5 6

Inhaltsverzeichnis

Seite 1 - Instruction Bulletin

™Instruction BulletinS1B35793Rev. 01, 08/2011Replaces S1B35793, 07/2011Wiser™ Thermostat Remote Temperature SensorModel EER57200 Retain for future use

Seite 2 - Temp. Sensor

WiserTM Thermostat Remote Temperature Sensor S1B35793Instruction Bulletin Rev. 01, 08/2011Electrical equipment should be installed, operated, service

Seite 3 - Boletín de instrucciones

™Boletín de instruccionesS1B35793Rev. 01, 08/2011Reemplaza S1B35793, 07/2011Sensor de temperatura remoto del termostato Wiser™Modelo EER57200 Conserva

Seite 4 - Sensor de temperatura

Sensor de temperatura remoto del termostato Wiser™ S1B35793Boletín de instrucciones Rev. 01, 08/2011Solamente el personal especializado deberá instal

Seite 5 - Directives d’utilisation

™Directives d’utilisationS1B35793Rév. 01, 08/2011Remplace S1B35793, 07/2011Capteur de température à distance du thermostat WiserMCModèle EER57200 À co

Seite 6 - FRANÇAIS

Capteur de température à distance du thermostat WiserMC S1B35793Directives d’utilisation Rév. 01, 08/2011Seul un personnel qualifié doit effectuer l’i

Kommentare zu diesen Handbüchern

Keine Kommentare

Schneider Electric EER57200 Bedienerhandbuch

Stöbern Sie online oder laden Sie Bedienerhandbuch nach Kühl- und Gefrierschränke Schneider Electric EER57200 herunter. Schneider Electric EER57200 Instructions / Assembly Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern